X-LABSBPC-157 10 MG VIAL RECONSTITUTION & HANDLING GUIDE
Back to X-Labs

X-LABS BPC-157 10 MG VIAL

RECONSTITUTION & HANDLING GUIDE

Simple instructions for preparing one 10 mg vial using bacteriostatic water.

1. Package contents

  • 1 × 10 mg BPC-157 vial (lyophilised peptide powder)
  • 1 × 3 mL bacteriostatic water
  • 3 × U-100 insulin syringes
  • 3 × alcohol swabs

2. Before you start

  • Wash and dry your hands thoroughly.
  • Work on a clean surface.
  • Use a new sterile syringe.
  • Do not use if seals are damaged.
BPC-157
10 mg
10 mg vial
BACTERIOSTATIC
WATER
3 mL
3 mL BAC water
U-100 insulin syringe

3. How to reconstitute ONE vial

1
Remove the small protective caps from the peptide vial and bacteriostatic-water vial. Clean both rubber stoppers with an alcohol swab.
BPC-157
10 mg
BAC WATER
3 mL
▧
2
Draw 1.00 mL (100 units) of bacteriostatic water into a U-100 syringe.
Full U-100 syringe =
1.00 mL = 100 units
3
Tilt the peptide vial slightly. Insert the needle and slowly let the 1.00 mL run down the inside wall of the vial. Do not force it directly onto the powder.
BPC-157
10 mg
4
Repeat Steps 2 and 3 two more times, adding 1.00 mL each time while the vial remains slightly tilted.
1.00 mL + 1.00 mL + 1.00 mL
Total bacteriostatic water added: 3.00 mL
5
Gently swivel the vial side to side until dissolved. Do NOT shake.
↺
BPC-157
10 mg
↻
6
The vial is now reconstituted with a total of 3.00 mL bacteriostatic water and is ready for use as directed by a qualified practitioner.
BPC-157
10 mg
Reconstituted
and ready for use
This guide provides reconstitution and handling information only. It does not provide an administration dose or treatment schedule.

4. Storage

  • After reconstitution, refrigerate at 2–8 °C.
  • Keep unused bacteriostatic water in a safe, dry place until needed.
  • Protect from heat, light and contamination.
❄

5. Important notes

  • Do not shake the vial — peptide compounds can be sensitive.
  • Use only as directed by a qualified practitioner.
  • Administration amount and schedule must be determined by a qualified practitioner.
  • Keep all components sterile during handling.

6. Disclaimer

For research / specialist use only. This guide provides general handling and reconstitution information only and does not replace medical advice. Use is subject to practitioner guidance and applicable law.